Aalto University Researchers Create Tiny Lasers Made from Nanoparticles

Researchers at Aalto are the first to develop a plasmonic nanolaser that operates at visible light frequencies and uses so-called dark lattice modes.

The researchers at Aalto University have made an array of nanoparticles combined with dye molecules to act as a tiny laser. The lasing occurs in a dark mode and the laser light leaks out from the edges of array.

The laser works at length scales 1,000 times smaller than the thickness of a human hair. The lifetimes of light captured in such small dimensions are so short that the light wave has time to wiggle up and down only a few tens or hundreds of times. The results open new prospects for on-chip coherent light sources, such as lasers, that are extremely small and ultrafast.

The laser operation in this work is based on silver nanoparticles arranged in a periodic array. In contrast to conventional lasers, where the feedback of the lasing signal is provided by ordinary mirrors, this nanolaser utilizes radiative coupling between silver nanoparticles. These 100-nanometer-sized particles act as tiny antennas. To produce high intensity laser light, the interparticle distance was matched with the lasing wavelength so that all particles of the array radiate in unison. Organic fluorescent molecules were used to provide the input energy (the gain) that is needed for lasing.

Light from the dark

A major challenge in achieving lasing this way was that light may not exist long enough in such small dimensions to be helpful. The researchers found a smart way around this potential problem: they produced lasing in dark modes.

“A dark mode can be intuitively understood by considering regular antennas: A single antenna, when driven by a current, radiates strongly, whereas two antennas -- if driven by opposite currents and positioned very close to each other -- radiate very little,” explains Academy Professor Päivi Törmä.

“A dark mode in a nanoparticle array induces similar opposite-phase currents in each nanoparticle, but now with visible light frequencies”, she continues.

“Dark modes are attractive for applications where low power consumption is needed. But without any tricks, dark mode lasing would be quite useless because the light is essentially trapped at the nanoparticle array and cannot leave”, adds staff scientist Tommi Hakala.

“But by utilizing the small size of the array, we found an escape route for the light. Towards the edges of the array, the nanoparticles start to behave more and more like regular antennas that radiate to the outer world”, tells Ph.D. student Heikki Rekola.

The research team used the nanofabrication facilities and cleanrooms of the national OtaNano research infrastructure.

The results have been published in the journal Nature Communications.

Further information:
Academy Professor Päivi Törmä
paivi.torma@aalto.fi
Tel: +358 50 3826770

Quantum Dynamics research group: http://physics.aalto.fi/en/groups/qd/

Centre of Excellence in Computational Nanoscience, COMP: http://comp.aalto.fi/

OtaNano: http://www.otanano.fi/

Video: https://www.youtube.com/watch?v=jXuAk17ycJA

Research article: T.K. Hakala, H.T. Rekola, A.I. Väkeväinen, J.-P. Martikainen, M. Nečada, A.J. Moilanen, P. Törmä. Lasing in dark and bright modes of a finite-sized plasmonic lattice. DOI:10.1038/NCOMMS13687.

Disclaimers of Warranties
1. The website does not warrant the following:
1.1 The services from the website meets your requirement;
1.2 The accuracy, completeness, or timeliness of the service;
1.3 The accuracy, reliability of conclusions drawn from using the service;
1.4 The accuracy, completeness, or timeliness, or security of any information that you download from the website
2. The services provided by the website is intended for your reference only. The website shall be not be responsible for investment decisions, damages, or other losses resulting from use of the website or the information contained therein<
Proprietary Rights
You may not reproduce, modify, create derivative works from, display, perform, publish, distribute, disseminate, broadcast or circulate to any third party, any materials contained on the services without the express prior written consent of the website or its legal owner.
Display devices have been used for many years as a means of HMI (Human Machine Interface) to connect humans and machines interactively, and their usage are still expanding. Automotive interiors are no exception to this trend, with an increasing ... READ MORE
About LiDAR Automotive industry trends In recent years, many vehicles have been launched with ADAS (Advanced Driver Assistance Systems) as standard equipment. As the future evolves towards more automated driving, sensing around the vehicle i... READ MORE