Avertronics ALAS Panel Light system equipped with a energy saving, intelligent control, fashionable and easy installation features. We use bluetooth wireless transmission module, allowing users control panel light via mobile application and blue tooth.

From the power drivers, light sensors, software to hardware control board, all designed and produced by Avertronics . Power driver can be simply installed, user-friendly and easy to operate with the interface of mobile application. With light sensor and intelligent hardware sensing program, can be easily installed and operating, even for beginners.

Avertronics ALAS panel light system can be used in commercial offices, shops or exhibition supplying by continuous electricity. The panel can control brightness depending external ambient light , such as sun light, greatly reduce the energy waste.

Avertronics ALAS panel light system features
1, energy efficiency

Avertronics ALAS panel light system surrounded by LED lights , collecting light source by converging board in the center, so that this design can transmit light downwardly and distribute light averagely, reduce dazzling and uneven brightness situation.

In order to extend the life of LED lamp , power drives and hardware control panel using the PWM technique and continuous switching, which allows the LED to reduce over -heat and power loss condition.

2, Automatic intelligence
Using light sensors to adjust the brightness, user can set 2 modes in mobile application, manual mode and automatic mode.

Manual mode: Users can adjust brightness by APP of mobile phone, turn off  panel light.

Automatic mode: User can assign the brightness of a particular environment, in mobile application, then save setting of brightness. It will automatically adjust brightness of panel light by user’s setting.

The following photo is operation interface.

 

3, Easy installation  

Ease installation is very important for users, therefore, Avertronics ALAS panel light system only equipped with power drivers , control board, panel light   , so that users can DIY easily for the first time. The following figures show main control board (Figure 1) and power driver (Figure 2).